The SHAPE Paparazzi with Bloc is an ergonomic-designed Paparazzi Handle screwed tight to a Rod Bloc by two 1/4″ screws. The Handle features a total of 20 screw-holes for attaching accessories, and the Bloc mounts 15mm rods and keeps the Handle parallel with a camera. You can slide the Bloc up and down the rods and tighten it into position by a red lever on the side. Both the Handle and Bloc are totally solid — not at all hollow — and are both water cut / laser cut, as opposed to being molded. The 20 screw-holes are a mix of 1/4″, 3/8″ and 1/2″ sizes and all run completely through from end to end. They are positioned vertically or horizontally along the Handle. The 1/4″ and 3/8″ holes can take on most any 1/4″ and 3/8″ accessories like lights, monitors, mics, grips, remote controls, recorders, articulating arms, wireless audio receivers, camera plates, and more. And into the 1/2″ holes you can screw in male-threaded SHAPE rods (2ROD15MF4, 2ROD15MF6) . The diverse set of screw-holes lets you get very creative in dressing up your rig. And the ability to screw in rods lets you just as creatively extend your rig.